39 lines
1.6 KiB
Markdown
Executable File
39 lines
1.6 KiB
Markdown
Executable File
# Ferris Sweep v2 Case
|
|
|
|
This is a remix of [Bubbleology's](https://www.printables.com/@Bubbleology) [Ferris Sweep v2 Case](https://www.printables.com/model/215167-ferris-sweep-v2-case). It is a combination of some of the model files which Bubbleology has made avaialble. Notably: 10mm bumpons, no PCB breakout recesses, and with a TRRS breakout.
|
|
|
|
This remix includes the following changes:
|
|
|
|
- Holes for attaching the PCB to this case have been widened to accept heat set threaded inserts. M2 x 5mm hardware is still used.
|
|
- Thes holes now extend through the body of the case so that a threaded insert can be fully set.
|
|
- The depth of the "floor" of the case has increased.
|
|
|
|
## Printing
|
|
|
|
I printed using PLA at the manufacturer's recommended temp of 220°.
|
|
|
|
- 25% infill
|
|
- 1.5 wall thickness
|
|
- No supports
|
|
- Bridge - probaby not necessary 🤷♂️
|
|
- Mirror for right side
|
|
|
|
## Hardware
|
|
|
|
- 14 x 10mm rubber bumpers (3/8 inch)
|
|
- 8 x M2 5mm bolts (6mm is probably ok but untested)
|
|
- 8 x [M2 heat set threaded insert](https://www.amazon.com/dp/B0CS6XJSSL?ref=ppx_yo2ov_dt_b_fed_asin_title)
|
|
- ~2mm thick foam
|
|
|
|
## Assembly
|
|
|
|
Place the printed case on something flat, sturdy, and heat resistant. Use a soldering iron to set threaded inserts into each hole, using little to no force to allow the brass insert to push all the way through and contact the work surface.
|
|
|
|
Cut 2mm foam to same shape as PCB, then use 5mm hardware to attach PCB to case with the foam as a gasket.
|
|
|
|
Refer to Bubbleology's original instrcutions for more details.
|
|
|
|
### Pictures
|
|
|
|
I haven't finished this build yet, but will add photos once it's done (along with any needed updates).
|